EMFF Series Pleated Filter Cartridges are manufactured to exact standards and are used in the most demanding industrial environments. The media has a fixed pore construction of high quality fibers providing a combination of surface and depth filtration. Due to use of premium quality filter fabrics, this pleated filter cartridges has superior flow characteristics with a very low pressure drop compared to depth media of similar micron ratings. This filters large surface area, increased dirt holding capacity, and innovative design provide a long service life, allowing you to reduce the number of cartridges used. Your advantage is a smaller filter vessel, less footprint and lower cost.
Operating Pressure and Temp: The pleated cartridge construction will withstand differential pressure up to 60 PSI (4 Bar) at ambient temperature. The optimum change out differential pressure is 35 PSI (2.5 Bar) up to 52°C.


Pressure Drop Performance






  • OD of 69mm, ID of 28mm
  • Convenient handling length of 40”
  • Available in 2µm, 5µm, 10µm and 20µm filter sizes
  • Material of Construction:

+ Filter Media : Polypropylene

+ End Cap Material : PP, ABS

+ Center Core : PP, ABS

+ Netting : PE + Seal Material : EPDM

+ End Cap Type: 222 / Flat end

+ Service Condition: 500 KPa at 20°C & 300 KPa at 65°C.


  • Completion brine
  • Process water
  • Industrial discharge water
  • Commercial bilge water
  • Surface water runoff
Diatomaceous Earth Powder (Diatomite Filter Aid)

Packing: 20 kg / woven bag (inner one-layer plastic paper)
Physical Properties Chemical Properties
Grade QH-700# Food grade SiO2 ≥ 80%
Color White powder Al2O3 ≤ 3%
Description Flux Calcined Filter Aid Fe2O3 ≤ 1.5%
Specific Gravity 2.3 g/cm3 CaO ≤ 0.6%
Moisture ≤ 0.5% MgO ≤ 0.5%
Loss on Ignition ≤ 0.3% P2O5 ≤ 0.8%
PH 8 – 11 Pb ≤ 0.4 mg/ kg
Bulk Density 0.45 g/cm3 Water Diffluence ≤ 25 mg/l
Permeability (Darcy) 5.5-7.0 Arsenite ≤ 1 ppm
Median Particle Size 44 µm Na2O + K2O < 2.7%